|
|
 | |
|
Model Pack 1 This is a starter pack of 3 control scenarios with built-in progression, fully supported with pupil activity sheets and teacher's notes |
 |
| Fairground | Create a light display. This uses outputs only. |
| Lighthouse | Create a program that flashes the light when the sun is not shining. This introduces the use of an input. |
| Car Alarm | Protect the car; make the headlights flash and the horn sound if the door is opened. This uses multiple inputs and outputs. Each model is supplied as a flat pack, with the outputs and inputs, wired and read to place in position. The outputs and inputs all have 4mm plugs. |
Also included in the pack are 3 on-screen mimics for use with Flowol software, allowing every available computer to be used, even if there is no model or interface connected.
 |
 |
 |
Model Pack One includes:
These ready-wired, flat packed models are designed to get you started –
useful for training courses.
Control
Models
 Clown Face |
 House |
 Giant Traffic Lights |
 Buggy |
Useful bits and pieces
| Spring Connectors (pack of 10) 4mm plugs with springs. An easy connction system for bare wires to Learn Go, FowGo and other control interfaces with 4mm sockets. The springs bend to trap bare wires. Easy LEDS A set of 6 LEDs, 2 red, 2 amber, 2 green, attached to a ribbon cable with 4mm plugs. Use for a light display or for traffic lights. |
 |
Input Kit
A pack of 4 different switches, wired and ready to use.
Control Kit
7
output devices and 3 switches with 20 spring connectors.
Includes 5
bulbs and holders, 1 motor with pulley, 1 buzzer, 1 push switch, 1
pressure mat and 1 light switch. All wired and ready to use
Analogue Sensors – all supplied with 3.5mm jack plug for use with Contact Controller interfaces or with the SOLO PIC system.
Temperature sensor – housed in
stainless steel tube - 6255
Temperature sensor – not housed - 6252
Light sensor – housed in plastic tube
- 6256
Light sensor – not
housed - 6253
